How to Configure LED Indicator in Door Phone

For the Akuvox door phone without a touch screen, you can check the device's status by the LED indicator's color and the blinking frequency. You can customize the LED status indicating the device's booting, upgrading, calling， talking, receiving incoming calls, and being offline.

Before Start

• Applicable device:
  E21A/E21V/ R20A/R20B/R20K/ R23C/R23P/ R26C/R26P/E11R/E12W/E12S

• Prerequisite:
  The device is connected to the power supply and boots up properly.

How to Configure LED indicator Status

For E21A/E21V/ R20A/R20B/R20K/ R23C/R23P/ R26C/R26P/E11R
Go to Intercom > LED Setting to configure.

E12 series use breath light, it is much different from the other linux doorphone' indicator show.

Go to Device > LED Setting to configure.

How to Configure Remote LED indicator Control

For E21A/E21V/ R20A/R20B/R20K/ R23C/R23P/ R26C/R26P/E11R
Go to Intercom > LED Setting to configure.

The format for the HTTP command is like this:
http://PhoneIP/fcgi/do?action=LedAction&State=1&Color=1&Mode=2500

State: 1=Idle; 2=OffLine; 3=Calling; 4=Talking; 5=Receiving;
Color: 1=Green; 2=Blue; 3=Red;
Mode: 0=Always On; 1=Always Off; 500/1000/1500/2000/25000/3000