The device can be connected to the Akuvox lift controller for the lift control. You can summon the lift to go down to the ground floor when you are granted access through access methods.
To set up the lift control, go to Device > Lift Control interface.
Lift Control List: Select Akuvox for integration with the Akuvox lift controller.
Lift Mode:
Choose Floor: Users can choose the floor they want to access when they use their credentials on the device.
Direct Access: Users will be directly sent to the target floor when they use their credentials on the device.
Server1 IP: The IP address of the lift controller that unlocks the elevator button(s).
Port: The port of the lift controller.
Server2 IP: Available when Direct Access is selected. The IP address of the lift controller that sends the lift control commands.
Port: The port of the lift controller.
User Name: Enter the user name of the lift controller for authentication.
Password: Enter the password of the lift controller for authentication.
Floor NO. Parameter: Enter the Floor number parameter provided by Akuvox.
URL To Trigger Specific Floor: Enter the URL for triggering a specific floor.
URL To Trigger All Floors: Enter the URL for triggering all floors.
URL To Close All Floors: Enter the URL used for closing all floors.
Floor Starts From: Set the floor from which the floor count starts. For example, if you select -3, then the 3rd floor in the basement will be considered as the first floor, matched with relay#1 (first floor).
Ground Floor: If there are ground floors between the -1 and 1 floors, configure this option.
Device Location: Select the floor where the device is installed.