Put HyPanel-KNX into Programming Mode

To transfer the configured parameters to the KNX devices, you need to perform a download using ETS. This action can only be performed after configuring the bus interface settings. For the download process, the KNX device may need to be in programming mode.

To put the KNX version of HyPanel in programming mode, swipe down from the top of any screen, select > System Settings > KNX Programming, and toggle it on.

Tip

To perform a download may require the device to be in its programming mode:

Download Options	Description	Programming Mode Required
Download All	Download all project data in ETS to the corresponding device.	Yes
Partial Download	Download only the parts that were changed in ETS and have not been downloaded before.	No
Download Individual Address	Assign individual address to KNX device.	Yes
Overwrite Individual Address	Assign individual address to KNX device by overwriting known address.	No
Download Application	Download application program into the device.	No