Update the system
Device update requires cloud connection. Alternatively, you can contact your service provider for assistance.
To update the device to the latest version, swipe down from the top edge of any screen to open Control Center, and tap 
> System Settings > Update. On the Update screen, do any of the following:
Toggle on Auto Update to update the firmware automatically. You can also set a specific update time period for the device to download and install available updates.
NOTE:
To upgrade the device in the preset time, the device must meet below 2 conditions：
The device is in the standby mode during the previous hour, and
The device does not have alarm and countdown set for the next hour.
If Auto Update is disabled, any available update must be downloaded and installed manually with your consent. To do this , tap Update.
NOTE:
If your system already installs the latest version, the screen shows no Update button.
Restart your HyPanel Lite
To restart the system, do any of the following:
Press the restart button at the bottom edge(refer to the picture) using a paperclip or needle until the display turns off.
Swipe down from the top edge of any screen to open Control Center, and tap
> Reboot.
Restore HyPanel Lite to installer settings
To reset your device, do as the following.
Swipe down from the top edge of any screen to open Control Center.
Tap
> System Settings > Reset.
NOTE：
The reset results depend on the device’s cloud connection status.
Devices with the cloud connection will return to the settings that your installer set up, and remove all user data and subsequently added devices.
Devices in the Auto Discovery mode will be reset to factory settings, and delete all user data and devices.
Please consult with your service provider before resetting devices.