Update the system
NOTE:
Device update requires cloud connection. Please contact your service provider for assistance.
Before upgrading, make sure the HyPanel Lux Vase battery level is above 80% or that the device is connected to a power charger. Otherwise, Auto Update will be disabled, and firmware upgrades via the cloud or web portal will not be available.
To update the device to the latest version:
Swipe down from the top edge of any screen.
Tap
> System Settings > Update. On the Update screen, do any of the following:
Enable Auto Update to automatically download and install firmware during idle time. You can also set a preferred update time period.
NOTE:
Updates will occur at the scheduled time only if:
The device has been in standby mode for the past hour, and
No alarms and countdowns are set within the next hour.
Disable Auto Update to download updates automatically but install them manually. If a new version is available, tap Install.
NOTE:
If your system already installs the latest version, the screen shows no Install button.

Restart the panel
To restart the device’s system, Swipe down from the top edge of any screen and tap
> Reboot.

Restore the panel to installer settings
To reset your device, do as the following.
Swipe down from the top edge of any screen to open Control Center.
Tap
> System Settings > Reset.
NOTE:
The reset results depend on the device’s usage mode your service provider selected in the initial setup.
Choosing the Installation Code option will reset the device to the settings that your installer set up, and remove all user data and subsequently added devices.
Selecting Local mode will initiate a reset to factory settings, and delete all user data and devices.
Please consult with your service provider before resetting devices.
Shut down the panel
To shut down the panel:
Swipe down from the top edge of any screen.
Tap
> Shut Down, then confirm.
NOTE:
If no action is taken after the confirmation dialog appears, the panel will automatically shut down after 60 seconds.

