Figure: Logic - AND/OR/XOR interface
Input a/b/c/d/e/f/g//h
Configure whether logic input x is involved in the operation, and it is normal or inverted.
Options:
Disconnected: Not involved.
Normal: The input directly involved.
Inverted: The input is inverted before being involved.
Note
The initial value of the input is not inverted.
Default value
Set the initial value of the logic input x.
Options:
0
1
Result is inverted
Determine whether the logical operation result is inverted.
Options:
No: Output directly
Yes: Invert and then output
Read input object value after bus voltage recovery
Decide whether a read request is sent to the logic input object following bus power recovery or programming.
Options:
No
Yes
Output send when
Set the conditions for sending the logical operation result to the bus.
Options:
Receiving a new telegram: Result sent upon each reception of a new logical input value.
Every change of output object: Result sent only when it changes.
Note
When conducting the initial logical operation, the result will be sent even if it remains unchanged.
Send delay time
Set the delay time for sending the logical operation result to the bus, calculated as Delay time = Base x Factor. If the “Base” is set to "None", there is no delay.
Base:
None
0.1s
1s
2s
5s
10s
25s
Factor: 1 .. 255