Screen Display and LED Setting
  • 23 Nov 2023
  • Dark
    Light
  • PDF

Screen Display and LED Setting

  • Dark
    Light
  • PDF

Article Summary

LED Setting on Card Reader Area

You can enable or disable the LED lighting on the card reader area as needed on the web interface. Meanwhile, if you do not want to have the LED light on the card reader area stay on, you can also set the timing for the exact time span during which the LED light can be disabled in order to reduce electrical power consumption.

To do this configuration, go to Intercom > LED Setting > LED Control.
image.png

Parameter Set-up:

  • Time (H): set the time interval for the light to stay on. enter the time interval for the LED light to be turned on, e.g., if the time interval is set from 8-0 (Start time- End time) it means the LED light will stay on during the time span from 8:00 am to 12:00 pm during one day (24 hours). This setting cannot be set up when you disable the LED light.

LED Settings on Keypad

You can enable or disable the LED lighting of the keypad as needed on the web interface. Meanwhile, if you prefer not to have the LED light of the keypad stay on, you can also set the timing for the exact time span during which the LED light can be enabled in order to reduce the electrical power consumption, etc. To do this configuration, go to Intercom > LED Setting > LED Control interface.
image.png

Parameter Set-up:

  • Time (H): enter the time span for the LED lighting to be valid. E.g. If the time span is from 18-22 it means LED light will stay on during the time span from 6:00 pm to 22:00 pm during a day.

LED Settings on Screen

You can enable or disable the LED lighting of the screen as needed on the web interface. Meanwhile, if you prefer not to have the LED light on the screen stay on, you can also set the timing for the exact time span during which the LED light can be enabled in order to reduce the electrical power consumption, etc. To do this configuration, go to Intercom > LED Setting > LED Control.
image.png

Parameter Set-up:

  • Wake Mode: there are two modes: Auto and Manual for waking up the device when idle. If you select Auto mode, then the screen will be awakened when someone approaches, and the IR sensor will be triggered. And if Manual mode is selected, then you have to press the keypad.
  • Time(H): enter the time span for the LED lighting to be valid. For example, if the time span is from 18-22, it means LED light will stay on during the time span from 6:00 pm to 22:00 pm during a day.

Was this article helpful?