WebRelay is an electrical relay with a built-in web server. It is controlled remotely by HTTP command, enhancing access control security.
This article takes IT88 as an example.
Steps
Use the device IP to log into its web interface. The default username and password are admin.
Navigate to the web Device > Relay interface.
Enter the IP Address, User Name, and Password provided by the Web Relay service provider.
Enter the IP or SIP number of the door phone connected to the door lock.
Enter the HTTP command in the Web Relay Action field. One of the example formats is state.xml?relayState=2.
Note
If you want to control more than one web relay using the HTTP Get method with a complete HTTP command, leave the IP address field blank. You can configure up to 50 commands.
If you did not enter the IP address, username, and password, you need to enter the complete HTTP command in a format such as http://{Username}:{Password}@{IP address}/state.xml?relayState=2.
For detailed instructions on Web Relay, please refer to the Web Relay manual on the WebRelay’s official website.
Users can open the door via various access methods after they are configured on the door phone.
Tip
For configuring access methods, you may refer to the Trigger WebRelay section in Configure WebRelay on Door Phones.